Troubleshooting

🟠 Possible Solution

The most likely issue is a missing DEVELOPMENT_TEAM for some Pods. The workaround is to put the following in App_Resources/iOS/Podfile (create one if your project doesn't have it already):

post_install do |installer|
  installer.pods_project.targets.each do |target|
    target.build_configurations.each do |config|
      # either set the DEVELOPMENT_TEAM explicitly
      config.build_settings['DEVELOPMENT_TEAM'] = '<TEAM_ID>'
      # or disable code signing
      config.build_settings['CODE_SIGNING_ALLOWED'] = 'NO'
    end
  end
end

Replacing <TEAM_ID> with your actual team id.

🟠 Possible Solution

This can happen when a library uses a symbol not avaialble in the current deployment target.

Increase the IPHONEOS_DEPLOYMENT_TARGET in your App_Resources/iOS/build.xcconfig:

IPHONEOS_DEPLOYMENT_TARGET = 13.0;

The above will increase the deployment target of the app, however you might also need to increase the deployment target of CocoaPods too. Put the following in your App_Resources/iOS/Podfile (create it if you don't have one):

platform :ios, '13.0'

post_install do |installer|
  installer.pods_project.targets.each do |target|
    target.build_configurations.each do |config|
      config.build_settings['IPHONEOS_DEPLOYMENT_TARGET'] = '13.0'
    end
  end
end

In this example we are setting it to 13.0 - change it to a version that makes sense for your project. Some libraries will require higher targets, so in most cases find the highest required target, and use that as your deployment target. Make sure to match both build.xcconfig and Podfile versions.

In case this doesn't resolve the issue, you can often delete the XCode DerivedData.

🟠 Possible Solution

Open the project in XCode (platforms/ios/<appname>.xcworkspace) and then select the project name in the left file tree. You should see General, Signing & Capabilities and other tabs in the middle. Select your device as the run target in the top bar, then select Signing & Capabilities and select an appropriate team, and if necessary press the Register Device button in the Profiles list.

Once the device is registered, you can exit XCode, and running the app from the NativeScript CLI should work as expected.

🟠 Possible Solution

Add the following lines to your shell profile, usually ~/.zshrc, or if you are using bash then ~/.bash_profile or ~/.bashrc config file:

export NODE_OPTIONS="--max-old-space-size=4096"

Reload your shell (eg, source ~/.zshrc) or open a new terminal window and try running again.

Note: you can increase this number further, but keep in mind the maximum value depends on the available system memory.